Our approach
- We start from published rules. The rules come from lighting retailers' and designers' sizing guides, and from building and accessibility codes where they apply.
- When sources disagree, we say so. We show the common range, explain the differences, and tell you which range we chose and why.
- Every calculation happens in your browser. Your measurements aren't sent anywhere or stored on our servers. Only your choice of inches or centimeters is remembered, in your own browser.
- Rules of thumb, not guarantees. These are design guidelines. A fixture's own spec sheet, your local electrical code, and your electrician have the final say.
Chandelier over a dining table
| What | Rule we use |
|---|---|
| Width | ½ to ⅔ of the table width, and at least 6″ inside each edge |
| Hanging height | Bottom 30–36″ above the table with an 8 ft ceiling, +3″ per extra foot, capped at 12 ft |
| Fixture height | 2.5–3″ per foot of ceiling, reduced if the ceiling is too low to fit it |
| Long tables | Suggest a linear fixture when the table is 72″+ long and 1.6× longer than wide: ½–⅔ of the length, 12″+ from each end |
| Cross-check | Room length + width in feet = width in inches |
| Table height | Assumed 30″ (76 cm) |
Where sources disagree: the hanging height. Wayfair's chandelier guide gives 30–36″ above the table. Some lighting retailers give 28–32″, and others 32–34″. We use 30–36″ because it's the most widely published range and contains the overlap of the others. Width rules also vary: some guides subtract 12″ from the table width instead of taking ½–⅔. We apply both, using ½–⅔ as the range and the 12″ rule as a cap.
For a source-by-source comparison of published chandelier and pendant guidance, see we checked 19 lighting guides.
Pendant lights over an island
| What | Rule we use |
|---|---|
| Count | 1 under 4½ ft, 2 up to 7½ ft, 3 up to 11 ft, 4 up to 14 ft, then 5 |
| Spacing | Length ÷ count, center to center, with the end pendants half a space from each end |
| Width of each | All pendants together ½ to ⅔ of the island length. Each stays 6″ inside the front and back edges, and a single pendant is capped at 30″. |
| Hanging height | Bottom 30–36″ above the counter, +3″ per foot of ceiling above 8 ft |
| Warnings | Less than 24″ center to center, or less than 6″ from shade to island end |
Where sources disagree: pendant size. One common rule makes each pendant about ¼ of the island length. Another, from Angi's pendant size chart, works from clearance to the edges. A third says the gap between pendants should equal one pendant's width. Our ½–⅔ total range contains all three for typical islands, and the article on pendant light spacing explains how shade size changes the look.
Room and foyer lights
| What | Rule we use |
|---|---|
| Width | Room length + width in feet = width in inches, ±2″. Metric: (length + width in m) × 8.3 = cm. |
| Headroom | At least 84″ (7 ft, 213 cm) from the floor to the lowest point |
| Style | Under 8 ft: flush. 8–9 ft: flush or semi-flush. 9–10 ft: semi-flush or small chandelier. 10 ft+: chandelier or pendant. |
| Two-story foyer | Up to 6″ wider than the formula. Center on the upstairs window, or bottom near the second-floor level. |
| Long rooms | Suggest two fixtures when the room is 16 ft+ long and 1.6× longer than wide |
The 7 ft headroom figure is the common design standard for walkways, and it matches typical guidance for ceiling fan blades.
Bathroom vanity lights
| What | Rule we use |
|---|---|
| Light width | 70–80% of the mirror width, never wider than the vanity |
| Mounting height | Bottom of the light about 3″ above the mirror. We assume an 8″ tall fixture to place the box center. The usual result is 75–80″. |
| Side sconces | Centers 60–66″ above the floor, about 4″ outside the mirror edge. We warn when they end up more than 40″ apart. |
| Bulbs | 2700–3000K color temperature, CRI 90 or higher |
Safety rule: the US National Electrical Code (NFPA 70, section 410.10(D)) keeps hanging fixtures, pendants and ceiling fans out of the zone 3 ft around and 8 ft above a bathtub rim or shower threshold. Bathroom fixtures should be rated for damp locations. Local codes may add to this.
Wall sconces
| What | Rule we use |
|---|---|
| Standard height | Center 60–66″ above the floor, or 66–72″ with ceilings of 10 ft or more |
| Hallways | No more than 10 ft apart, using the same equal-section method as pendants. We also show the 8 ft option. |
| Narrow hallways | Warn to keep projection at 4″ or less when the hall is under 5 ft wide |
| Pairs beside art or a mirror | Level with the upper third of the piece, centers 6–12″ beyond each edge |
| Bedside | Centers 20–30″ above the mattress top, over the nightstands, or 8″ beyond the mattress without them |
The 4″ projection limit comes from the 2010 ADA Standards (section 307.2), which apply to wall-mounted objects between 27″ and 80″ above the floor in public buildings. It isn't required at home, but it's a good guide for narrow halls. Bedside heights vary the most between sources, which is why we give a 10″ range.
Ceiling fans
| What | Rule we use |
|---|---|
| Blade span | Up to 75 sq ft: 29–36″. Up to 144: 36–42″. Up to 225: 44–50″. Up to 400: 50–54″. Larger: 60″+, or two fans. |
| Two fans | Rooms over 400 sq ft, or 20 ft+ long and twice as long as wide. Each fan is sized for half the room. |
| Downrod | The common length (0, 3, 6, 12, 18, 24, 36, 48, 60 or 72″) that puts the blades closest to 8½ ft, within 8–9 ft, using the fan's own height from its spec sheet |
| Clearances | Blades at least 7 ft above the floor, and tips about 18″ from walls |
Where sources disagree: the size tiers come from This Old House. Home Depot and Wayfair shift them by a few inches. Fan makers' downrod rules of thumb also differ (Hunter uses ceiling height minus 9 ft), so we work from the fan's own height instead. ENERGY STAR advises the 7 ft floor clearance and 10–12″ below the ceiling.
Recessed lighting
| What | Rule we use |
|---|---|
| Spacing | Ceiling height ÷ 2, adjusted so each row divides evenly into the room |
| From the walls | Half the spacing |
| Count | Room length ÷ spacing and width ÷ spacing, each rounded to the nearest whole number, multiplied |
| Brightness check | Total lumens compared with the room's target. "Too dim" below 90% of the low end; "brighter than needed" above 125% of the high end. |
Where sources disagree: the distance from walls. Some guides use a full half ceiling height (4 ft on an 8 ft ceiling), and Philips suggests 1½–2 ft. Half the spacing keeps the grid even and lands inside both ranges on typical ceilings.
Lumens
| Room | Foot-candles (lumens per sq ft) |
|---|---|
| Hallway or stairs | 5–10 |
| Living room, bedroom | 10–20 |
| Dining room, kitchen (general) | 30–40 |
| Home office | 30–50 |
| Bathroom, kitchen counters | 70–80 |
Lumens needed = area × foot-candles. Metric uses lux (1 fc = 10.764 lux). These are the ranges US retailers such as Home Depot publish. Lists credited to the Illuminating Engineering Society give lower bathroom and higher bedroom levels, which the calculator points out. Bulb equivalents (40 W = 450 lm, 60 W = 800 lm, 75 W = 1,100 lm, 100 W = 1,600 lm) are ENERGY STAR's minimums.
Chain length
Chain = ceiling height − canopy − fixture height − bottom height. The bottom height uses the same rules as the chandelier and island calculators: 30–36″ above the table or counter, plus 3″ per foot of ceiling above 8 ft. Over open floor, the bottom sits between 7 and 8 ft. For rods, we pick the whole number of rods closest to the middle of the range.
What the calculators don't do
- Only the recessed lighting and lumens calculators check brightness. A correctly sized decorative fixture can still be too dim or too bright on its own.
- They don't know your fixture's weight. Ceiling boxes are usually rated for up to 50 lb (23 kg), and heavier fixtures need a box listed for their weight or separate support (NEC 314.27).
- They don't replace local code or an electrician's judgment.
Corrections
We update this page and the affected calculators whenever we change a rule, and the date at the top shows the last change.